A8 Quattro Sedan V8-4.2L (BVJ) (2008)
‹› Removing and installing, refer to => [ Connecting Link ] See: Suspension Strut / Shock Absorber/Service and Repair/Front Suspension.
18
Bolt, 40 Nm + 90° additional turn
‹› Always replace.
‹› Raise the wheel bearing housing before tightening. Refer to => [ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See:
Wheel Bearing/Service and Repair/Procedures.
19
Bolt, 150 Nm + 90° additional turn
‹› Tighten in a diagonal sequence, using bolt - item 8 -.
‹› Always replace.
‹› The threads in the body can be repaired using thread inserts made of wire according to DIN 8140 (Heli-Coil(R)). The thread insert must be the
same length as the threads in the body. Refer to => [ Longitudinal Member Threads, Servicing ] See: Service and Repair/Procedures/Front
Suspension/Longitudinal Member Threads, Servicing.
20
Bolt, 38 Nm
‹› Remove and install the 2 bolts evenly.
21
Stabilizer Bar
‹› With cast rubber bushings and clamps.
‹› Removing and installing, refer to => [ Stabilizer Bar ] See: Stabilizer Bar.
‹› Note the different suspension versions. Refer to => [ PR Number Explanations ] See: Application and ID.
22
Bolt
‹› Mounting on the body.
23
Engine Carrier
‹› Removing and installing:
‹› For the 4.2L and 5.2L engines, refer to, left and right engine mounts. See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and
Accessories/Engine Mount/Service and Repair
‹› For the 6.0L engine, refer to, engine and transmission, separating. See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine and
Transmission, Separating
24
Bolt
‹› For the engine mount.
25
Washer
26
Self Locking Nut, 56 Nm
‹› Always replace.
27
Cross Brace
‹› Note the installed position: the outer semicircular opening must be at the top right.
28
Engine Mount
29
Bolt
30
Bolt, 10 Nm