A8 Quattro Sedan V8-4.2L (BVJ) (2008)
/Page-2406004.png)
-
Remove the (T10149) and the (VAG 1383A).
Right Side
-
To tighten the bolts further, raise the suspension into the control position. Refer to => [ Wheel Bearing Housing, Raising to Control Position to
Tighten Bolts ] See: Rear Knuckle/Service and Repair/Procedures.
-
Tighten the stabilizer bar clamp bolts - 1 - evenly. Refer to - item 4 - in => [ Stabilizer Bar, Track Control Arm, Tie Rod, Coupling Rod,
Connecting Link, Trailing Arm and Level Control System Sensor Assembly Overview ] See: Stabilizer Bar, Track Control Arm, Tie Rod,
Coupling Rod, Connecting Link, Trailing Arm and Level Control System Sensor Assembl.
-
Tighten the stabilizer bar bolt - arrow - to the coupling rod. Refer to - item 5 - in => [ Stabilizer Bar, Track Control Arm, Tie Rod, Coupling Rod,
Connecting Link, Trailing Arm and Level Control System Sensor Assembly Overview ] See: Stabilizer Bar, Track Control Arm, Tie Rod,
Coupling Rod, Connecting Link, Trailing Arm and Level Control System Sensor Assembl.
