A8 Quattro Sedan V8-4.2L (BVJ) (2008)
/Page-2464004.png)
Installing
-
Tighten the bolts/nuts on components with bonded rubber bushings by hand. Raise the wheel bearing housing to tighten the bolts/nuts. Refer to =>
[ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See: Rear Knuckle/Service and Repair/Procedures.
-
Engage the trailing arm - 1 - in the wheel bearing housing and connecting link - 2 - and insert the bolt - 3 -.
-
Tilt the trailing arm upward and press it into the mounts on the subframe.
-
Install the bolt - 3 - and then bolt - 4 -.
