A8 Quattro Sedan V8-4.2L (BVJ) (2008)
Wheels: Removal and Replacement
Metal Valve Body
Metal Valve Body
Special tools, testers and auxiliary items required
‹› Torque wrench (VAG 1410)
-
Place the metal valve with rubber seal through the wheel from the inside.
-
Position the beveled washer and union nut from the outside and tighten. Refer to - item 7 - in => [ Wheel Electronics Assembly Overview ] See:
Alignment/Service and Repair/Procedures/Wheel Electronics Assembly Overview.
-
Secure against turning with a counter holder - 1 - (fir example, a 2 mm diameter drill bit).
-
Press the wheel electronics - 1 - into the bed and fasten at the rear of the valve with the microencapsulated screw. Refer to - item 6 - in => [ Wheel
Electronics Assembly Overview ] See: Alignment/Service and Repair/Procedures/Wheel Electronics Assembly Overview.