A8 Quattro Sedan V8-4.2L (BVJ) (2008)
-
To remove, unscrew lower bolt - 3 -.
-
Unclip upper seal from door and pull off seal.
-
Adhesion surface must be free of dust and grease.
-
Before installing, clean adhesion surface on door - 1 - with D 009 401 04.
-
To install, clip seal - 2 - into door at top first.
-
Pull off protective foil from below until over area of impression.
-
Bond seal in area of impression.
-
Affix lower formed piece and bond on seal completely in lower area.
-
Pull off remaining protective foil and bond on seal in upper area.
-
Press seal firmly onto door.
-
Bolt seal at bottom with bolt - 3 -.