A8 Sedan V8-3.7L (AEW) (1997)
/Page-2262001.png)
On Board Computer: Service and Repair
Steering Column Switches, Removing and Installing
WARNING!
-
Airbag system components must only be checked, removed, installed and/or repaired by qualified Service Department personnel
-
Before starting work on any parts of the airbag system, disconnect the battery Ground (GND) strap. When reconnecting the Ground
strap, the passenger compartment must not be occupied.
-
Always refer to airbag system safety precautions.
CAUTION!
Before working on the electrical system:
-
Determine the correct coding for the anti-theft radio.
-
Switch the ignition off.
-
Disconnect the battery Ground (GND) strap.
Removing
-
Disconnect battery Ground strap.
-
Turn front wheels and steering wheel to straight-ahead position.
-
Pull adjustable steering column out as far as it will go and set to lowest position.
-
Using Torx: T30 bit, remove screws for airbag unit from left and right sides of back of steering wheel.
-
Tightening torque: 7 Nm (62 in.lb.)
-
Carefully pivot airbag unit toward front.
-
Disconnect harness connector from rear of airbag unit and place airbag unit facing up.
