A8 Sedan V8-3.7L (AEW) (1997)
Rear Door Window Regulator: Service and Repair
"Up to m.y. 1999"
Rear Window Regulator, Removing And Installing
-
Rear door trim removed
1
-
Rear window regulator
-
To remove, drill off rivet heads - 2 - and knock out rivet shafts
-
Securely rivet window at point designated by arrow first
2
-
Pop rivet (6x)
-
To avoid contact corrosion, use only genuine Audi rivets
=> parts catalog microfiche
3
-
Door component carrier
4
-
Window regulator motor
-
Disconnect harness connector Fig. 1
-
After installing, run window up to stop.
-
Activate all power window switches ("up") for at least one second to activate automatic window raising/lowering.