A8 Sedan V8-3.7L (AEW) (1997)
Control Module: Service and Repair
5 Speed Automatic 01V FWD
Removing And Installing TCM -J217-
Removing
-
Switch ignition off.
-
Open E-box in right side of plenum by unscrewing 7 bolts (arrows).
-
Unclip bolt cover to unscrew bolt in upper right-hand section of illustration.
-
Release multi-pin connector lock -2-, then disconnect multi-pin connector from TCM.
-
Unscrew bolts (arrows) and remove TCM from E-box.
-
Check container for water penetration and reseal if necessary.
Installing
-
Install in reverse order of removal.
-
Check DTC memory of TCM.
Disconnecting multi-pin connector from TCM -J217-