A8 Sedan V8-3.7L (AEW) (1997)
Combination Switch: Mechanical Diagrams
Component Notes And Information
1
Upper Steering Column Trim
2
Bolt
-
Tighten to, 5 Nm (44 inch lb)
3
Phillips-Head Screw
-
Quantity: 2
-
Tighten to, 1 Nm (9 inch lb)
4
Steering Column Adjustment Switch
5
Phillips-Head Screw
-
Tighten to, 1 Nm (9 inch lb)
6
Phillips-Head Screw
-
Quantity: 2
-
Tighten to, 1 Nm (9 inch lb)
7
Lower Steering Column Trim
8
Phillips-Head Screw
-
Quantity: 2
-
Tighten to, 1 Nm (9 inch lb)
9
Bolt
-
Tighten to, 2.5 Nm (23 inch lb)
10
Bolt
-
Quantity: 2
-
Tighten to, 6 Nm (53 inch lb)
-
Torx T25
11
Steering Wheel With Coil Spring (Clockspring)
-
Coil Spring (Clockspring) Removal/Installation, refer to Air Bags and Seat Belts
12
Nut
-
Tighten to, 40 Nm (30 ft lb)
13
Airbag Unit
WARNING: Before the steering wheel is removed:
^
The ground strap (GND) must be disconnected from the battery.
^
The 1-pin connector for the power supply of the air bag system must be disconnected
^
The front wheels must be turned to the straight-ahead position.
^
Failure to observe this instruction will result in the coil spring being over-tensioned, which will cause failure of the airbag system.