A8L V8-4.2L (BFM) (2004)
/Page-6965002.png)
-
Unscrew window regulator motor.
-
Slide the door window down.
-
Using a small flat screwdriver, unclip retaining clips - 2 - on the top side between sun shade - 4 - and retaining clips - 2 -.
-
Pull shafts - 5 - out of mounts - 3 -. When doing this, hold sun shade firmly in place so that it is not drawn in.
-
A second technician is needed for the next two steps.
-
Hold cover - 1 - open and let the sun shade - 2 - roll in until there is only a small portion left.
-
Drive in the shafts via switch in roof module, while doing this the switch in roof module must remain pressed for a minimum of 5 seconds.
