A8L V8-4.2L (BFM) (2004)
Fuel Gauge Sender: Locations
Fuel Tank With Attachments, Overview of Components
Fuel tank with attachments, overview of components
1 - Securing strap
^
With spacer, installing location; Refer to Fig. 2
2 - 22 Nm
3 - Fuel supply pipe
^
From fuel filter
^
To fuel rail
^
Press release tab on connection piece to disconnect
4 - Fuel return pipe
^
Mark before disconnecting
^
Press release tab on connection piece to disconnect
^
Clip onto fuel tank
5 - Vent pipe
6 - Ground (GND) connection
^
To eliminate electrostatic charge
^
Position / test procedure; Refer to Fig. 1.
^
Ensure that connector is fitted properly
^
After installation, use an ohmmeter to check the electrical connection of the fuel filler neck on a bare metal part on the body.
^
Specification: approximately 0 ohms
7 - Sealing cap
8 - Seal
^
Replace if damaged 9-22 Nm
10 - Electrical harness connector
^
For fuel tank lock switch
11 - Vent pipe
^
To EVAP canister in rear left wheel housing
^
Clip onto fuel tank