A8L V8-4.2L (BFM) (2004)
-
Cut the corrugated tube to the appropriate length.
‹› Use (VAS 6228) or a sharp knife for cutting.
‹› The corrugated tube must not be cut through using a side cutter under any circumstances
‹› The corrugated tube must be cut on the wave peak - arrow -, not in the wave trough.
-
Guide fiber optic cable into (VAS 6223/10) as shown in illustration.
-
Position crimping pliers for fiber optic cable at slot of corrugated tube.
-
Position crimping pliers for fiber optic cable at slot of corrugated tube. By doing this, fiber optic cable is fed in corrugated tube.
Disconnecting from Wiring Harness Connector
Removing