A8L V8-4.2L (BFM) (2004)
/Page-690001.png)
Suspension Control Module: Procedures
Level control system control module -J197-, removing and installing
Removing
^
If the control module is to be replaced, in the "Guided fault-finding" select the "Replace" function of the relevant control module.
Use vehicle diagnostic, testing and information system VAS 5051 for this purpose.
Note: The level control system control module -J197- is installed behind the glove box on the bulkhead.
^
Removing glove compartment.
^
Remove air duct in front of control unit.
^
Release the connector -1- from the control module in the direction of the arrow and detach.
^
Remove control unit -2-.
Installing
Installation is in reverse order. Note the following:
^
Perform the adaptation procedure for level control system control module -J197-.
