A8L V8-4.2L (BFM) (2004)
-
Disconnect electrical connector from the front self-leveling sensors
-
Remove nut -2-
-
Remove screws -3- and remove self-leveling sensor -1-
-
Install new self-leveling sensor -1- (4E0 941 285 E/F) and right self-leveling sensor (4E0 941 286 E/F) reusing bolts -3- and tighten to 5 Nm (44
in. lbs.)
IMPORTANT: Self-leveling sensors must be installed in pairs with the identical suffix parts. "E" suffix parts CANNOT be mixed with "F" suffix
parts.
NOTE: The self-leveling sensor lever must point forward
-
Secure sensor linkage to control arms using new nuts (N 011 183 12) and tighten to 8 Nm (71 in. lbs.)
-
Reconnect electrical connectors to the front self leveling sensors
-
Proceed to Section B.
Section B - Rear Self-Leveling Sensors Replacement
-
Disconnect electrical connectors from the rear self-leveling sensors