A8L Quattro Sedan V8-4.2L (AKB) (2002)
/Page-1894002.png)
Fig. 4 Pressing out bonded rubber bushing
a - Hex bolt M12 x 90 x 1.5
^
Position tool 3351/1 on subframe.
^
Slip bolt -a- through bushing, bridge piece and cross-piece 3351/4, then install.
^
Pull out one side of bonded rubber bushing by turning threaded stem -a-
Fig. 5 Pressing out bonded rubber bushing
^
Turn subframe round.
Note: Install special tools 335112 and 335113 as shown in Fig. 1. and Fig. 2.
^
-a- = Hex bolt M 12 x 90 x 1.5
^
Position tool 3351/1 on subframe.
^
Slip bolt -a- through bushing, bridge piece and cross-piece 3351/4, then install.
^
Pull out second side of bonded rubber bushing by turning threaded stem -a-.
Fig. 6 Aligning bonded rubber bushing
^
Position subframe in direction of travel.
^
Arrows on bonded rubber bushings must point in direction of travel.
^
Use a long straight piece of rectangular tubing or straightedge to align bushings.
