A8L Quattro Sedan V8-4.2L (AKB) (2002)
/Page-1170002.png)
9. Pin
^
Insert in fork head and brake pedal
10. Torsion spring
^
Press into pedal bracket until stop
11. Vent valve for cruise control system
12. Brake light switch
13. Hex bolt, 20 Nm
14. Clip
^
Always replace
^
Insert in bearing bracket
15. Mounting bracket
^
Removing and installing; Refer to pedal assembly
16. Clutch pedal
^
Secured via adjustment of clutch master cylinder
^
Slide onto shaft of bearing bracket
^
Can be removed and installed with pedal bracket installed.
17. Circlip
^
Always replace
^
Install on pin
18.
Pin
^
Insert in clutch pedal and master cylinder
19. Cylinder bolts, 20 Nm
20. Clutch master cylinder
^
Replace if leaking
^
To remove, unscrew bearing bracket
^
Adjusting, Refer to Fig. 1
21. Gasket
^
Insert between pedal bracket and master cylinder
22. Supply hose
^
Install on master cylinder
23. Bearing bushing
^
Replace if damaged
24. Torsion spring
^
Do not lubricate
^
To remove, unscrew bearing bracket
25. Hexnut, tighten to 20 Nm.
^
Always replace
Fig. 1 Adjusting clutch master cylinder
a = 114.5mm ± 0.5 mm
-
To adjust, turn plastic bearing eyelet.
Note:
^
When measuring, plastic bearing eyelet must be at right angle to surface of clutch master cylinder.
^
If the clutch pedal does not return on its own with plastic bearing eyelet properly adjusted:
-
There may be air in the hydraulic system
-
The pedal may be stuck in the bearing.
