A8L Quattro Sedan V8-4.2L (AKB) (2002)
-
Remove sealing plug -arrow- from cylinder block on left side.
-
Top Dead Center (TDC) mark on crankshaft must be behinds bore (can be touched) of removing sealing plug.
-
Install -3242- in hole of the removed sealing plug and tighten.
Note:
The toothed belt tensioner is oil-dampened. Compress it by slowly applying constant pressure.
-
Turn toothed belt tensioning lever -1- towards left in direction of -arrow- using 8mm hex socket wrench until tensioner -2- is compressed far
enough so that -T40011- fits in hole and plunger.
-
Insert -T40011- and release toothed belt tensioning lever.
-
Install -T40005- in locking plates of camshafts.
-
Loosen both bolts for camshafts approximately 5 turns.
-
Remove -T40005-.