A8L Quattro Sedan V8-4.2L (AKB) (2002)
Air Door Actuator / Motor: Service and Repair
Center Vent Adjusting Motor -V102-
Center vent adjusting motor -V102-, removing and installing
NOTE: Mark connector for the motor when removing (danger of swapping with connectors of the other actuator motors).
-
Remove driver-side shelf and side trim of center console
-
Remove 2 screws -A-.
-
Remove motor from air conditioner housing.
-
Before installing the servo motor, check mounting of the flap (knob -C- must be located between the stops -B-).
-
If the shaft of the servo motor is located in such an unfavorable position that it is not possible to install See Notes regarding installation.
-
After installing, always check DTC memory.
-
Tighten securing screws -A- only by hand, tightening torque 4 Ncm (0.35 in. lb).