audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Air Flow Flap Motor -V71-|Page 4741 > < Air Flow Flap Motor -V71-|Page 4739
Page 1
background image

Air Door Actuator / Motor: Service and Repair
Defroster Flap Motor -V107-

Defroster flap motor -V107-, removing and installing

NOTE:  Mark connector for the motor when removing (danger of swapping with connectors of the other actuator motors).

-

Remove driver-side shelf and side trim of center console

-

Remove footwell air outlet.

-

Remove 2 screws -A-.

-

Remove flap motor (linkage -B- with lever remains connected to air conditioner housing).

-

If the shaft of the flap motor is located in such an unfavorable position that it is not possible to install motor -> Notes regarding installation.

-

After installing, always check DTC memory.

-

Tighten securing screws -A- only by hand, tightening torque 4 Ncm (0.35 in. lb).

Air Flow Flap Motor -V71-|Page 4741 > < Air Flow Flap Motor -V71-|Page 4739