A8L Quattro Sedan V8-4.2L (AKB) (2002)
^
Take off brake disc.
^
Remove nuts -2- and -3-.
^
Pullout rubber grommet -1- and separate connector -2-.
^
Pull ABS speed sensor wiring from retainers -arrows-.
Do not damage the rubber grommet!
^
Remove bolt with washer -3- and bolt -4-.
Notes:
^
Discontinuation of bolt with washer 3- at right tie rod, Refer to Wheel Bearing Housing (Steel), Removing and Installing.
^
Wheel alignment after carrying out repairs, Refer to Alignment, Description and Operation.
^
Pull out tie rod.
^
Remove nut from joint pin.
Note: For safety reasons, reinstall collar nut on track control link joint pin and tighten flush (approximately 4 turns).