A8L Quattro Sedan V8-4.2L (AUX) (2001)
-
Lightly coat hatched surface of double bearing cap as well as outer bearing cap next to camshaft adjuster with sealant and install bearing cap.
-
Install remaining bearing caps.
-
Replacing and installing oils seals for intake and exhaust camshafts. Refer to: and to: for CMP sensor.
-
Carefully drive in cap using -3202-.
-
Rotate crankshaft at mounting bolt for toothed belt sprocket clockwise approximately 45° to TDC again and secure crankshaft using locking pin.
Further installation is in reverse order of removal, note the following:
-
Install toothed belt. Refer to Vehicle/ Engine, Cooling and Exhaust/ Engine/ Timing Components/ Timing Belt/ Service and Repair/ See: Timing
Components/Timing Belt/Service and Repair
-
Install cylinder head cover. Refer to: Vehicle/ Engine, Cooling and Exhaust/ Engine/ Cylinder Head Assembly/ Valve Cover/ Service and Repair/
See: Cylinder Head Assembly/Valve Cover/Service and Repair
Note:
-
After installing the camshafts, the engine may not be started for approximately 30 minutes. The hydraulic adjusting elements must seat themselves
(otherwise the valves will seat themselves on the pistons).
-
After working on the valvetrain, carefully rotate engine by hand at least 2 full revolutions to ensure that valves do not strike the pistons when
starting.
Tightening Specifications: