A8L Quattro Sedan V8-4.2L (AUX) (2001)
^
If necessary, apply Vaseline to the contact surface of the impulse wheel in order to keep it in proper position during installation.
-
Press bracket (together with ball bearing) onto left drive flange as follows:
Place drive flange on pressure plate VW 401.
Press bracket on using thrust disc VW 412, tube VW 415 A and driving sleeve 32-109.
CAUTION: The press tube 2040 shown in the illustration should not be used (it is too short). Use tube VIN 415 A instead
-
Install circlip (arrow -A-).
-
Install left drive flange.
-
Check final drive fluid level and correct as necessary refer to Transmission and Drivetrain.
-
Tighten the following to:
Left drive flange bracket to transmission: 23 Nm (17 ft lb)
Drive axle to drive flange M10: 77 Nm (57 ft lb)
Drive axle to wheel hub M16 bolt (always replace): 200 Nm (148 ft lb) + 90°
Heat shield to transmission: 23 Nm (17 ft lb)