A8L Quattro Rear Knuckle Service and Repair: Wheel Bearing Housing (Bearing Pressed In)
/Page-1533004.png)
^
Position tools 3293 and 3349 such that claws engage between flange of bonded rubber bushings and wheel bearing housing.
^
Pull one of the bonded rubber bushings with nut, washer and threaded spindle from 3290.
Fig. 6 Pressing out second bonded rubber bushing
Tool arrangement
1 - Bonded rubber bushing
Note: The tool arrangement is shown here without wheel bearing housing. The actual work procedure is shown in the next figure.
^
Insert 3349/1 thrust piece and insert spindle from 3290.
^
Attach 3349 special tool to bonded rubber bushing -1-.
^
Pull bonded rubber bushing out by turning nut on threaded spindle.
Fig. 7 Pressing in bonded rubber bushing
^
Install new bushing in Wheel bearing housing using thrust pieces 3292/3 and threaded spindle from 3292.
Note: Install bushings carefully to avoid tilting.
