A8L Quattro Sedan V8-4.2L (AUX) (2001)
The same nut must be used. Otherwise, the original installed position cannot be found.
^
Make sure pinion nut and threads on pinion are free of oil and grease and coat threads lightly with locking compound, D 000 600.
^
Place drive shaft flange on pinion and install using driving sleeve 3143 until pinion nut can be installed.
^
Tighten pinion nut to exact original position (previously marked).
^
Carry out control measurement of dimensions -a- and -b- in order to make sure installation is OK.
Note:
The dimensions may deviate by a maximum of ± 0.5 mm (0. 020 inch) from the preliminary measurements.