A8L Quattro Sedan V8-4.2L (BVJ) (2007)
-
Pry the front interior lamp - 1 - out using the pry lever (80 - 200) as shown in the illustration.
-
Pivot front interior light downward and remove from roof trim.
-
Unplug multi-pin connector.
-
Press retainer tab - 1 - at multi-pin connector.
-
Unclip securing bracket of connectors - arrow - and disconnect connectors.
-
Unplug remaining connectors.
Installing
Install in reverse order of removal, observing the following:
-
Engage interior light and bolt on.
If roof electronics control module (J528) was replaced, it must be re-coded.