audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Voltage Supply of Engine Control Module (ECM), Checking|Page 1276 > < Voltage Supply of Engine Control Module (ECM), Checking|Page 1274

A8L Quattro Sedan V8-4.2L (BVJ) (2007)

Page 3
background image

Set the adjustment on the heat gun as shown in the illustration, with the temperature potentiometer - 2 - set to maximum heat and the two stage air flow
switch - 3 - set to level 3.

CAUTION!
By heating the threads, the retaining tabs, shear bolts and parts of the metal housing become very hot. Do not burn yourself on this!
Make sure that only the threads are heated as much as possible, and not any of the surrounding parts. Possibly cover these parts.

Heat threads on the connector side of the shear bolts as shown in the illustration.

Switch on the heat gun and heat the bolt for approximately 20 to 30 seconds.

-

Remove the shear bolts using locking pliers in the - direction of the arrow -.

Voltage Supply of Engine Control Module (ECM), Checking|Page 1276 > < Voltage Supply of Engine Control Module (ECM), Checking|Page 1274