A8L Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-4214001.png)
Wiring Harness: Procedures
Antenna Wires, Repairing
Antenna Wires, Repairing
A repair procedure has been developed for repairing antenna wires. Instead of a complete antenna wire, connecting wires of different lengths and
various adapter leads are now available as replacement parts.
‹› Do not repair antenna wires. Replace them using connector and adapter wires available as original replacement parts.
‹› These original replacement parts are suitable for all antenna wires and wire cross sections that need to be replaced.
‹› Individual antenna connectors are not designed to be replaced.
‹› The wires must be used retroactively for all Audi models, for all installed antenna wire diameters.
‹› All adapter leads and connecting wires are suitable for various transmission and reception signals.
‹› The repair concept can also be used as a testing or retrofitting solution.
Special tools, testers and auxiliary items required
‹› - 1 - Adapter wire, for connection to radio; length: approximately 30 cm
‹› - 2 - Connecting wire, available in various lengths
‹› - 3 - Adapter wire, for connection to antenna; length: approximately 30 cm
Procedure
Example: Antenna wire from radio to antenna is faulty.
-
Separate the connectors of the faulty antenna wiring from their components.
-
Determine the path of the faulty antenna wire in the vehicle and measure the total length of antenna wire to be replaced.
‹› The entire length of the antenna wire consists of the length of the required adapter wires - 1 and 3 - and the connecting wire - 2 -.
