A8L Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-4856005.png)
-
Install the speed sensor - 2 - in the wheel bearing housing and tighten the bracket bolt. Refer to - item 21 - in => [ Air Spring Damper, Wheel
Bearing Housing and Wheel Hub and Bearing Assembly Overview ] See: Suspension Control ( Automatic - Electronic )/Service and Repair/Rear
Suspension.
-
Insert the brake caliper connector - 1 - into the retainer and connect it.
-
Follow the instructions for further assembly. Refer to => [ Working after Adjusting Control Position ] See: Procedures.
-
Tighten the drive axle bolt. Refer to => [ Installing ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Suspension/Drive Axle.
-
Install the wheel and tighten.
-
Place the vehicle on its wheels. Refer to => [ Positioning Vehicle on the Hoist and on its Wheels ] See: Service and Repair/Procedures/Positioning
Vehicle on the Hoist and on its Wheels.
-
Perform a vehicle alignment. Refer to => [ Wheel Alignment ] See: Alignment/Service and Repair/Procedures/Wheel Alignment.
