Audi Workshop Service and Repair Manuals

‹› Always replace.

‹› Rest the vehicle on its wheels (standard level) before tightening.

7

Bolt, 4 Nm

8

Air Spring Damper

‹› The boot must not have any pressure points. Correct them if necessary. Refer to => [ Air Spring Damper Boot, Correcting Pressure Points ] 

See: Suspension Control ( Automatic - Electronic )/Air Spring/Service and Repair/Procedures/Rear Suspension/Air Spring Damper Boot,
Correcting Pressure Points.

‹› Note the different suspension versions. Refer to => [ PR Number Explanations ] See: Application and ID.

‹› Removing and installing, refer to => [ Air Spring Damper ] See: Suspension Control ( Automatic - Electronic )/Air Spring/Service and

Repair/Removal and Replacement/Rear Suspension.

‹› Disassembling and assembling, refer to => [ Air Spring Damper ] See: Suspension Control ( Automatic - Electronic )/Air Spring/Service and

Repair/Procedures/Rear Suspension/Air Spring Damper.

9

Track Control Arm

‹› Removing and installing, refer to => [ Track Control Arm ] See: Trailing Arm/Service and Repair/Track Control Arm.

10

Self Locking Nut

‹› Always replace.

11

Bolt, 80 Nm + 90° additional turn

‹› Always replace.

12

Self Locking Nut

‹› Always replace.

13

Wire Channel

14

Eccentric Bolt

‹› Adjust the camber after loosening. Refer to => [ Rear Camber, Adjusting ] See: Alignment/Service and Repair/Procedures/Rear Camber,

Adjusting.

‹› Do not turn more than 90° right or left (that is smallest to largest possible adjustment).

15

Wheel Bearing Housing

‹› Removing and installing, refer to => [ Wheel Bearing Housing ] See: Rear Knuckle/Service and Repair/Removal and Replacement/Rear

Suspension/Wheel Bearing Housing.

‹› Bushing removing and installing, refer to => [ Wheel Bearing Housing Bushing ] See: Rear Knuckle/Service and Repair/Removal and

Replacement/Rear Suspension/Wheel Bearing Housing Bushing.

16

Eccentric Washer

‹› Inner bore with tab.

17

Self Locking Nut, 95 Nm

‹› Always replace.

‹› Raise the wheel bearing housing before tightening, refer to => [ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See:

Rear Knuckle/Service and Repair/Procedures, (except for vehicle alignment).

18

Self Locking Nut, 75 Nm + 45° additional turn