A8L Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-4947003.png)
‹› Always replace.
19
Washer
20
Connecting Link
‹› Connects the tie rod with the wheel bearing housing and trailing arm.
‹› Removing and installing, refer to => [ Connecting Link ] See: Connecting Link.
21
Self Locking Nut
‹› Always replace.
22
Bolt, 80 Nm + 90° additional turn
‹› Always replace.
‹› Raise the wheel bearing housing before tightening. Refer to => [ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See:
Rear Knuckle/Service and Repair/Procedures.
23
Trailing Arm
‹› Removing and installing, refer to => [ Trailing Arm ] See: Trailing Arm/Service and Repair/Trailing Arm.
24
Bracket
‹› For the brake line.
25
Self Locking Nut, 50 Nm + 90° additional turn
‹› Always replace.
‹› Raise the wheel bearing housing before tightening. Refer to => [ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See:
Rear Knuckle/Service and Repair/Procedures.
26
Self Locking Nut
‹› Always replace.
27
Bolt, 80 Nm + 90° additional turn
‹› Always replace.
‹› Raise the wheel bearing housing before tightening. Refer to => [ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See:
Rear Knuckle/Service and Repair/Procedures.
28
Bracket
‹› For the brake line.
29
Bolt, Self Locking, 10 Nm
‹› Always replace.
30
Bolt
‹› Always replace.
31
Self Locking Nut, 80 Nm + 90° additional turn
‹› Always replace.
‹› Raise the wheel bearing housing before tightening. Refer to => [ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See:
Rear Knuckle/Service and Repair/Procedures.
