A8L Quattro Sedan V8-4.2L (BVJ) (2007)
-
Remove the threaded connection nuts - 1 through 4 - for the trailing arm - 6 -.
-
Remove the bolt - 5 - from the trailing arm/connecting link.
-
Raise the wheel bearing housing to the control position to continue removing the bolts. Refer to => [ Wheel Bearing Housing, Raising to Control
Position to Tighten Bolts ] See: Rear Knuckle/Service and Repair/Procedures.
-
Remove bolt - 3 - and then bolt - 4 -.
-
Remove the trailing arm downward from the mounts on the subframe and tilt it downward.
-
Disengage the trailing arm - 1 - from the connecting link - 2 - and remove the bolt - 3 -.