A8L Quattro Sedan V8-4.2L (BVJ) (2007)
/Page-3162003.png)
-
Remove left - 1 - and right - 2 - transmission bolts on tunnel cross member.
-
Remove transmission tunnel cross member - arrows - from body.
-
Lower or raise transmission accordingly using Engine/Transmission Jack V.A.G 1383 A until transmission is horizontal in installation position
again.
Note:
^
The transmission must be level to check the axle oil.
^
It must be raised or lowered accordingly using Engine/ Transmission Jack V.A. G 1383 A after removing the tunnel cross member.
-
Slide tunnel cross member as far back as possible so that transfer case oil inspection and filler plug - arrow - is accessible.
-
Place used oil collection and extraction device V.A.G 1782 under transmission.
Note:
^
Observe disposal regulations.
CAUTION!
Wear eye protection.
-
Remove transfer case oil inspection and filler plug - arrow -.
