A8L Quattro Sedan W12-6.0L (BSB) (2005)
/Page-1957012.png)
-
If necessary, turn camshafts back and forth slightly using 32 mm open-end wrench. Camshaft bar (T10068) must not be installed during this
process.
-
Remove camshaft bars (T10068).
-
Remove crankshaft holder (3242).
-
Screw sealing plug of TDC marking with new seal into the guide frame.
The rest of the installation is in reverse order of removal, note the following:
-
Install cylinder head covers => [ Installing ] See: Cylinder Head Assembly/Valve Cover/Service and Repair.
-
Install intake manifold lower-section => [ Intake Manifold Lower-Section ] See: Intake Manifold/Service and Repair/Intake Manifold
Lower-Section.
-
Install intake manifold upper-section => [ Intake Manifold Upper Section ] See: Intake Manifold/Service and Repair/Intake Manifold Upper
Section/Cylinder Head, Valvetrain.
-
Install drive plate => [ Drive Plate ] See: Transmission and Drivetrain/Flex Plate/Service and Repair/Drive Plate.
