Allroad Quattro V6-2.7L Turbo (APB) (2002)
/Page-1613006.png)
^
Re-install coolant hose between thermostat housing and radiator.
^
Remove coolant hose -1- from thermostat housing to front water pipe.
Tip:
Save both spring clamps to be used later.
^
Install auxiliary coolant pump assembly in place of removed coolant hose.
^
Use 2 original spring clamps which were used for installation of the removed coolant hose.
Tip:
The spring clamps need to be pre-installed onto the coolant hoses prior to connecting the coolant hoses to fittings.
^
Install the 2 coolant hoses of auxiliary coolant pump assembly onto fittings of thermostat housing and front water pipe as shown.
^
Ensure that coolant hoses have clearance from surrounding components (adjust if necessary).
^
Secure coolant hoses with spring clamps-arrows- (position locking tabs of spring clamps as shown -arrows-).
^
Fasten auxiliary coolant pump bracket to Alternator bracket (see illustration) using self cutting screw -1- Part No: N 100 835 02 (tighten screw to a
torque of 9 Nm
