Allroad Quattro V6-2.7L Turbo (APB) (2002)
Note:
^
Watch position of guide bushings when installing.
^
When installing, insert bolt -1- in the compressor first.
^
To prevent damage to the condenser and refrigerant lines/hoses, ensure that the lines and hoses are not stretched, kinked or bent.
-
Drain engine oil.
Note: Use a separate container to collect the engine oil.
-
Remove lower section of oil pan.
Installing
Install in the opposite order to removing. When installing, note the points:
Note: Do not use any adhesive or sealant.
-
Clean sealing surfaces; ensure that they are free of oil and grease.
-
Install new gasket on lower section of oil pan and install on upper section of oil pan with two diagonally opposite bolts.
-
Tighten all securing bolts hand-tight.
-
Tighten bolts to 10 Nm with torque wrench, working from center outward.
-
Install new seal on oil drain plug and tighten to 30 Nm.
-
Fill engine with oil.
-
Install lock carrier in normal position.
-
Install bumper.