Allroad Quattro V6-2.7L Turbo (APB) (2002)
/Page-564001.png)
Wheel Speed Sensor: Service and Repair
Front Axle
ABS wheel speed sensor, removing and installing
Removing
-
Loosen wheel bolts.
-
Raise vehicle.
-
Remove wheel.
-
Remove grommet -1- from wheel housing.
-
Disconnect ABS wheel speed sensor harness connector -2-.
-
Disconnect ABS wheel speed sensor wiring from retainers (arrows).
-
Pull ABS wheel speed sensor out of wheel bearing housing.
When installing, pay particular attention to the following points
-
Replace clamping sleeve, Refer to Brakes and Traction Control; Service and Repair.
-
Before installing speed sensor, install sealing cuff.
-
Connect ABS wheel speed sensor wiring and snap grommets into retainers.
-
Turn wheels completely to left and right stop positions and check ABS wheel speed sensor wiring clearance.
