Allroad Quattro V6-2.7L Turbo (APB) (2002)
/Page-2602004.png)
-
Selector lever in "P" , start engine and let it run at idle.
CAUTION! Let engine run at high speed at "2500-3000 RPM" for approx. 4 to 5 seconds immediately after starting.
Running the engine at high speeds is necessary so that the ATF pump is bled after a transmission repair.
If running at high speeds is not performed, the transmission can be damaged.
-
Start engine
-
By pressing the gas pedal, run engine at high speed at "2500-3000 RPM" for approx. 5 seconds.
-
Press brake pedal and hold.
-
Shift through all selector lever positions "P, R, N, D, S" and let each position remain shifted at idle for approx. 2 seconds.
-
Selector lever in "P" and let engine continue to run at idle.
-
Thread connection on shut-off valve of ATF filler system F/CVT gearbox VAS 5162 from ATF check plug opening - B - .
-
Allow excess ATF to drain off.
-
Install ATF check plug - B - .
-
Tightening torque: 20 Nm.
