Allroad Quattro V6-2.7L Turbo (APB) (2002)
-
Press clutch and brake pedal pivot pin out to the right, until the clutch pedal can be removed.
-
If necessary press brake pedal securing clip off pivot pin with a screwdriver.
-
Take out clutch pedal and over-center spring.
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
Align the clutch pedal/brake pedal pivot pin so that it protrudes out of mounting bracket at the clutch pedal side (arrow).
-
First hook the clutch pedal into the over-center spring, then fit onto pivot pin.
-
Connect clutch pedal to master cylinder. Clip pin onto clutch pedal.
-
Do not tighten bolt (arrow) until both securing clips have been fitted on the clutch pedal/brake pedal pivot pin.