Allroad Quattro V6-2.7L Turbo (APB) (2002)
/Page-2710002.png)
^
Replace
4. Shim "S1"
^
Note thickness
^
Adjustment overview
5. Outer race for large taper roller bearing 1)
^
For differential
^
Driving out and driving in
6. Outer race for small taper roller bearing 1)
^
For differential
^
Driving out and driving in
7. Shim "S2"
^
Note thickness
^
Adjustment overview
8. Seal
^
For input shaft
^
Levering out see Fig. 3
^
Driving in see Fig. 5
^
Always replace when removing input shaft
^
Replacing when transmission is not disassembled see Fig. 4 and Fig. see 5
9. Oil drain plug, 40 Nm
10. Ball sleeve
^
For selector shaft
^
Replace
^
Pulling out see Fig. 6
^
Driving in see Fig. 7
11. Ball sleeves
^
For selector shafts
^
Replace
^
Pulling out see Fig. 6
^
Driving in see Fig. 7
12. Circlip
^
Installation position: eyes facing up
13. Switch for reversing lights, 20 Nm
14. O-ring
^
For cover for selector shaft
^
Replace
15. Cover for selector shaft
^
Removing
^
Installing
16. Ball stud, 20 Nm
^
For connecting rod
17. Outer race for large taper roller bearing 1)
^
For drive pinion
^
Pulling out
^
Pressing in
18. Circlip
^
Removing see Fig. 16
19. Shim "S3"
^
Note thickness
^
Adjustment overview
20. Needle bearing
^
For input shaft
^
Pulling out see Fig. 13
^
Driving in see Fig. 14
^
Measuring insertion depth see Fig. 15
21. Locking bolt
^
For selector shaft
^
Removing
^
Installing
^
Tightening torques: -or aluminum bolt = 50 Nm, and for steel bolt = 70 Nm
22. Stud, 40 Nm
^
For pushrod
^
No longer installed m.y. 1999
23. Breather
^
Clip cap on
^
For transmission with sleeve
