Allroad Quattro V6-2.7L Turbo (APB) (2002)
Shifter M/T: Removal and Replacement
Gear Lever Boot and Gear Knob From My 2002 Remove and Install
Parcel Shelves/covers
Gear Lever Boot And Gear Knob From MY 2002 remove And Install
Gear knob in Sport version
Arrow points in direction of travel.
Removal
-
Release the gear lever boot - 2 - by lifting the clip.
-
Rotate the gear lever boot - 2 - under the gear knob - 1 - by 45 Degrees counterclockwise.
-
Remove the gear knob - 1 - together with the gear lever boot - 2 - by pulling it upward.
Installation
-
Press the gear knob - 1 - into the drive position on the gear shift lever.
-
Rotate the gear lever boot - 2 - under the gear knob - 1 - by 45 Degrees clockwise.
-
Clip the gear lever boot - 2 - on.
Gear Knob In Standard Version
The figure shows the gear lever boot inside out.
Removal
-
Release the gear lever boot - 1 - by lifting the clip.
-
Turn the gear lever boot - 1 - inside out by pulling it upward.
-
Rotate the locking device - 2 - by 45B clockwise.
-
Remove the gear knob together with the gear lever boot - 1 - by pulling it upward.
Installation