Allroad Quattro V6-2.7L Turbo (APB) (2002)
Seals and Gaskets: Service and Repair
6 Speed Manual 01E
Drive flange of seals, replacing
Special tools, testers and auxiliary items
^
Drift 2062
-
Observe general repair instructions.
Note: All the illustrations show the left side of the final drive. Removal and installation is the same for the drive flange and seal on the right hand
side.
Removing
Rear final drive installed
-
Remove heat shields from final drive (arrows).
-
Place drip tray underneath.
-
Unbolt drive shaft.
-
To loosen the securing bolt, screw two bolts into the drive flange and counter-hold with a lever.
-
Lever seal out with a lever.
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
Lightly oil outer circumference of seal.