Allroad Quattro V8-4.2L (BAS) (2004)
-
Once door handle is inserted and locked in place in mount, use auxiliary tool to push in locking pin - 2 - in direction of arrow.
-
Spring clip (arrow -B-) on locking pin - 2 - must fully lock home around fulcrum lever - 1 -.
Peened rivet (arrow - A -).
Releasing door handle mount
-
Using small screwdriver, disengage retainer for slide (arrow -A-) by lifting it slightly.
-
Using offset open-end wrench (17 mm), release slide - 3 - of mount - 2 - in direction of arrow - B -.
Removing trim panel
-
To remove, pull up door handle - 2 -, use small screwdriver to push out retainer - 1 - and remove trim - 3 -.