Allroad Quattro V8-4.2L (BAS) (2004)
Trunk / Liftgate Shock / Support: Service and Repair
Removing And Installing Gas-filled Strut
Removing
-
Using screwdriver, push back retaining springs slightly at both ends of gas-filled strut and unclip gas-filled strut.
NOTE: When removing or installing the gas-filled strut, push back the opened rear lid slightly without damaging the components.
Installing
-
Clip in gas-filled strut at bottom first, then at top. Install with tube end of strut at rear lid
Releasing gas from strut
-
Clamp gas-filled strut in vice in area - x -.
Dimension -x- = 50 mm (2 in.)
-
Using saw, cut into cylindrical part of strut at point within first third of cylinder's length (measured from piston rod end of cylinder).
WARNING: The gas-filled strut must only be clamped in the vice at the area indicated; otherwise there is a risk of accident.
NOTE: Always wear eye protection when performing this procedure. Cover the sawing area with a clean rag to contain any escaping fluid.