Allroad Quattro V8-4.2L (BAS) (2004)
-
Drive out pad retaining pins (arrows).
-
Remove retaining pins (arrows).
Note: Before pushing back piston, siphon some of the brake Fluid out of the brake Fluid reservoir. Otherwise, especially if reservoir has been
topped off, Fluid will overflow and cause damage.
-
Press off the brake pads from the brake disc and remove them from the brake caliper housing.
Installing
Note: Press piston back into caliper housing using resetting tool before inserting new brake pads. Before pushing back the piston, draw off brake Fluid
out of the brake Fluid reservoir with a bleeder bottle. Otherwise, especially if reservoir has been topped off, Fluid will overflow and cause damage.
-
Press piston back.
-
Insert brake pads into brake caliper housing
Note: The brake pads are directional, note the markings on the damping panel.
-
Install retaining springs (arrows).
-
Press retaining springs downward and drive in pad retaining pins to stop.