Allroad Quattro V8-4.2L (BAS) (2004)
/Page-1694004.png)
-
Disconnect connector -1- at high pressure sensor -G65-.
-
Remove bolts (arrows).
-
Detach condenser and swivel downward with lines connected.
-
Release both retaining pins for radiator and lift up (arrows).
-
Swivel top edge of radiator forward and lift up radiator.
Installing
Install in reverse order, paying attention to the following:
-
Fill with coolant.
Note: The entire coolant must be replaced following radiator replacement.
-
Attach ATF lines:
-
Install front bumper.
-
Check ATF level.
Tightening torques
