Allroad Quattro V8-4.2L (BAS) (2004)
/Page-1442004.png)
-
Insert spur gears -1- to -3-.
-
Attach dust cap (arrow) to end of shaft of spur gear for AC compressor drive.
-
Check whether the 2 dowel sleeves have been installed in the rear bearing cap and insert if necessary.
-
Install rear bearing cap and tighten bolts as follows.
1. Bolts 1, 3, 7
^
To 10 Nm
2. Bolts 2, 4, 5, 6, 8, 9
^
Diagonally and in stages
-
Hand-tighten drive sprocket for PTO chain.
-
Install PTO chain.
-
Tighten drive sprocket for PTO chain to 62 Nm.
