Allroad Quattro V8-4.2L (BAS) (2004)
-
Disconnect connector (arrow) at oil pressure switch.
-
Remove oil pressure switch.
-
Connect oil pressure tester VAG 1342 with adapter 1342/14 to hole for oil pressure switch.
-
Screw oil pressure switch -2- into V.A.G 1342.
Checking oil pressure switch
-
Connect brown wire -1- of tester to ground (GND)
-
Connect voltage tester VAG 1527 B with test leads from VAG 1594 A to oil pressure switch and battery positive
^
LED must not light
-
If LED lights, replace oil pressure switch.
-
Start engine.
Note: Observe tester and LED on starting, as switching point of oil pressure switch may already be exceeded when starting.
^
LED must light at 1.2 to 1.6 bar
-
If LED does not light, replace oil pressure switch.
Checking oil pressure
-
Start engine (engine oil temperature approximately 90°C).
^
Oil pressure at 2000 rpm: min. 2.0 bar
^
Oil pressure at 3500 rpm: min. 3.5 bar
^
Oil pressure at higher engine speed: max. 4.0 bar
If readings do not match specifications:
-
Pressure relief valve/oil pump is faulty, replace oil pump.
Note: Replace oil seal on installing oil pressure switch.
Tightening torque