Allroad Quattro V8-4.2L (BAS) (2004)
-
Pre-tighten camshaft bolt -1- at exhaust camshaft of left cylinder head.
^
Tightening torque: 40 Nm
-
Fix Hall sender rotor ring in position at adjuster of inlet camshaft of left cylinder head with locator T40047. - Position locator at bolt -1 -.
-
Pre-tighten camshaft bolt -2- at inlet camshaft.
^
Tightening torque: 40 Nm
-
Fix Hall sender rotor ring in position at adjuster of inlet camshaft of right cylinder head with locator T40047.
-
Position locator at bolt -2-.
-
Pre-tighten camshaft bolt -1- at inlet camshaft.
^
Tightening torque: 40 Nm
-
Detach locator.
-
Pre-tighten camshaft bolt -2- at exhaust camshaft of right cylinder head.
^
Tightening torque: 40 Nm
Note: Camshaft locators are not to be used to provide support when finish-tightening camshaft bolts.