Allroad Quattro V8-4.2L (BAS) (2004)
-
Connect up voltage tester VAG 1527 B as follows.
-
Briefly operate starter.
^
LED must light
-
Switch ignition off.
If LED does not light:
-
Use wiring diagram to check for open circuit in wiring from contact 1 of connector via fuse to fuel pump relay.
-
Use wiring diagram to eliminate open circuit in wiring.
If LED lights:
Checking actuation
^
Vehicle diagnostic, testing and information system VAS 5051 connected up; vehicle self-diagnosis and vehicle system "01 Engine electronics"
selected. Ignition must be on.
-
Connect voltage tester V.A.G. 1527 B to contacts 1 (positive) and 2 of connector.
Indicated on VAS 5051:
-
From list -1- select diagnostic function "03- Final control diagnosis".
-
Touch > key, until Valve -1- for camshaft adjustment -N205- is activated.
^
LED must flash
-
Touch > key again, until Valve -2- for camshaft adjustment -N208- is activated.
^
LED must flash
-
Terminate function "03- Final control diagnosis" by touching < key.
-
Switch ignition off.
If LED does not flash or if it is permanently lit: