Allroad Quattro V8-4.2L (BAS) (2004)
-
Insert 3307 fuel pump wrench through fuel tank opening into inner part of accumulator.
-
Using 3307 fuel pump wrench, turn fuel pump module approx. 15 degrees to right (to stop).
-
Notch -1- must then align with marking -2- (bayonet lock)
-
Lift out fuel pump together with inner part of accumulator.
Installing
Installation is the reverse of removal, however note the following:
NOTE: Replacement hose clamps must be the same type of clamp that was used in production
-
Install fuel pump module into tank with notch -1- on fuel pump module lining up with marking -2- on outside of fuel pump module.
-
It should feel that it is possible to press fuel pump module down.